We are pleased to present, in serial form, Chapter 9 of Analysis and Design of Analog Integrated Circuits, Fifth Edition by Paul R. Gray, Paul J. Hurst, Stephen H. Lewis and Robert G. Meyer. These excerpts are from the recently released Fifth Edition.
Part 5 of ADLE's serialisation of 'Analysis and Design of Analog Integrated Circuits' concerns the behaviour of feedback circuits with large input signals. It explores the effect of frequency compensation on their large-signal, high-frequency performance, how to calculate feedback amplifier stability, and compensate for it using the root-locus technique, previously referred to in Pt. 4.
There are five parts, the fifth, and last, of which now appears below:
Part 1, pages 624 to 643, click here
Part 2, pages 643 to 650, click here
Part 3, pages 650 to 664, here
Part 4, pages 664 to 681, here
Part 5, pages 681 to 703, here
Often referred to as 'the standard text' for Analog Design, this book by two IEEE Fellows and their colleagues, all well-known analog designers, aims to provide a comprehensive treatment of analog integrated circuit analysis and design starting from the basics and through current industrial practices. Although written as an academic text, suitable for students with a grounding in analog design, its comprehensive coverage of bipolar, CMOS, as well as BiCMOS analog integrated-circuit design
would make it a worthwhile addition to most practicing analog engineer's bookshelves too.
In this recently updated edition (January, 2009), coverage of the bipolar 741 op amp has been replaced with a low-voltage bipolar op amp, the NE5234, and the authors have extended their use of SPICE. They note that this is because SPICE acts as a more accurate check on hand calculations, and also as a tool to examine complex circuit behaviour beyond the scope of hand analysis.
The Table of Contents:
1. Models for Integrated-Circuit Active Devices
2. Bipolar, MOS, and BiCMOS Integrated-Circuit Technology
3. Single-Transistor and Multiple-Transistor Amplifiers
4. Current Mirrors, Active Loads, and References
5. Output Stages
6. Operational Amplifiers with Single-Ended Outputs
7. Frequency Response of Integrated Circuits
9. Frequency Response and Stability of Feedback Amplifiers
10. Nonlinear Analog Circuits
11. Noise in Integrated Circuits
12. Fully Differential Operational Amplifiers
More details can be found at the publisher's catalogue page here
The book is published by John Wiley & Sons Inc., ISBN: 978-0-470-24599-6, copyright 2009, excerpted with permission, all rights reserved.