REGISTER | LOGIN
Home    Bloggers    Blogs    Article Archives    Messages    About Us   
Tw  |  Fb  |  In  |  Rss
Blogs
Content posted in April 2011
Deliver the lowest distortion and noise in a low-power, wideband, ADC interface (Part 1 of 4)
Steve Taranovich  
4/25/2011   5 comments
Combine a low-power, very-high dynamic range, fully-differential amplifier (FDA) with a few simple circuit tricks, to deliver the lowest noise and distortion signal to a high-performance ADC.




latest blogs
Analog circuits inherently have some inaccuracies; if these exceed the allowable specification, there are three general strategies to dealing with them.
Removing the vuvuzela narrow-band noise was presenting challenges to broadcast engineers
This article discusses how using a single synchronous buck controller can output the most common voltage rails, and accommodate a wide range of operating input voltages from 3V to 40V, and at a reasonable BOM cost.
This article explains how the latest-generation SiC FETs are ideally suited to new inverter designs with lower losses than IGBTs and proven robustness against short circuits, even at high temperatures and under repetitive stress
flash poll
educational resources
 
follow Planet Analog on Twitter
Planet Analog Twitter Feed
like us on facebook
our partners
Planet Analog
About Us     Contact Us     Help     Register     Twitter     Facebook     RSS