REGISTER | LOGIN
Home    Bloggers    Blogs    Article Archives    Messages    About Us   
Tw  |  Fb  |  In  |  Rss
Dennis Feucht
Content posted in September 2015
Feedback Circuits and Two-Port Blocks, Part 3: Using Ports to Analyze Feedback Circuits
Dennis Feucht  
9/15/2015   Post a comment
In this third part, a feedback circuit example is used to illustrate how ports simplify feedback analysis.
Feedback Circuits and Two-Port Blocks, Part 2: Feedback Circuit Misconceptions
Dennis Feucht  
9/1/2015   Post a comment
Typical circuits textbooks tell us that there are four basic feedback topologies. The impression is given (if not stated) that a given feedback circuit will conform to one of these four topologies. This is misleading. One of the tasks of feedback analysis, it would seem, is to identify to which of the four basic topologies a given feedback circuit conforms. This article attempts to clarify and correct this misconception.




latest blogs
Removing the vuvuzela narrow-band noise was presenting challenges to broadcast engineers
This article discusses how using a single synchronous buck controller can output the most common voltage rails, and accommodate a wide range of operating input voltages from 3V to 40V, and at a reasonable BOM cost.
This article explains how the latest-generation SiC FETs are ideally suited to new inverter designs with lower losses than IGBTs and proven robustness against short circuits, even at high temperatures and under repetitive stress
There’s a further cool thing you can do with a spreadsheet that most SPICEs can’t. That’s to use the spreadsheet ‘solver’ functionality to adjust component values in the search for a better-fitting circuit – or even to find a set of component values for a circuit you can’t otherwise design.
flash poll
educational resources
 
follow Planet Analog on Twitter
Planet Analog Twitter Feed
like us on facebook
our partners
Planet Analog
About Us     Contact Us     Help     Register     Twitter     Facebook     RSS