REGISTER | LOGIN
Home    Bloggers    Blogs    Article Archives    Messages    About Us   
Tw  |  Fb  |  In  |  Rss
Frederik Dostal

Optimized Power Supply Measurement Setup

Frederik Dostal
More Blogs from Frederik Dostal
Fast switching transitions can yield some disadvantages. Interference in the frequency range of the switching transitions between approximately 20 MHz and 200 MHz increases dramatically.
There is a great deal written about isolation, but Frederik Dostal gives us a look at power supply isolation. Do you know which side of the galvanic isolation to put the controller? Should you use optocouplers or some other method? Find out here
In such things as laboratory power supplies or electronic systems, in which various components are connected to longer cables, the regulated voltage is not always particularly accurate at the point where it is needed due to various voltage drops across the interconnection lines.
Where do I connect the grounds of switching regulators?
flash poll
educational resources
 
follow Planet Analog on Twitter
Planet Analog Twitter Feed
like us on facebook
our partners
Planet Analog
About Us     Contact Us     Help     Register     Twitter     Facebook     RSS