REGISTER | LOGIN
Home    Bloggers    Blogs    Article Archives    Messages    About Us   
Tw  |  Fb  |  In  |  Rss
Maximizing output power from PLL synthesizer high-frequency open-collector outputs
1/18/2019

< Previous   Image 5 of 6      Next >

Figure 4
Single-ended output power vs. pull-up component type for the TI LMX2594 synthesizer

Single-ended output power vs. pull-up component type for the TI LMX2594 synthesizer

< Previous   Image 5 of 6      Next >

Return to Article

AaronHe
AaronHe
3/13/2019 3:24:59 AM
User Rank
Newbie
About the pull-up component
Hi Dean:

How about set the pull-up components as an inductor parallelled with a resistor for example 50 ohm. Choose the inductor value big enough at the working frequency to make the parallelled impedance is almost same as the resistor. And this added inductor will remove the DC voltage drop which could guarantee the output signal will have full voltage swing.

50%
50%
More Blogs from Signal Chain Basics
Most people are not familiar with electromechanical spinning. My goal here is to attempt to explain brushless-DC motors simply
The latest direct radio frequency (RF)-sampling transceivers provide a number of powerful capabilities that enable advanced system features like multiband and multimode operation, as well as frequency translation and fast frequency hopping.
A transimpedance amplifier (TIA), which takes the current from a photodiode and converts it into a usable voltage with low output impedance, can provide effective gain for a photodiode signal.
In this article, Iíll provide an overview of SAR ADC reference input behavior and reference input drive circuit topologies
flash poll
educational resources
 
follow Planet Analog on Twitter
Planet Analog Twitter Feed
like us on facebook
our partners
Planet Analog
About Us     Contact Us     Help     Register     Twitter     Facebook     RSS